April 13, 2026 — Passed
10 red flags recorded · 120 minutes on site.
- Properly wash, rinse and sanitize all food contact surfaces. Make a 100 ppm bleach sanitizing solution or a 200 ppm quaternary ammonia solution for the third compartment.
- Provide exhaust hoods to remove toxic gases, heat, grease, vapors, and smoke and be approved by the local building department. Canopy-type hoods shall extend 6 inches beyond all cooking equipment. Toilet rooms shall be vented to the outside air by a screened openable window, an air shaft, or a light-switch activated exhaust fan, consistent with local building codes. Adequate lighting shall be provided in all areas to facilitate cleaning and inspection. Light fixtures in areas where open food is stored, served, prepared, and where utensils are washed shall be of shatterproof construction or protected with light shields.
- Maintain nonfood contact surfaces clean. Thoroughly clean and degrease the cooking equipment and shelves above cooking equipment.
- Provide soap and single-use towels in dispensers, or a drying device at each handwash sink at all times. Maintain all handwash sinks unobstructed and accessible at all times.
- Rapidly cool potentially hazardous foods from 135°F to 70°F within 2 hours, then from 70°F to 41°F within 4 hours. Discontinue cooling PHF's at room temperature. Rapid cool by any of the following approved methods: 1) Ice water bath 2) Ice wand 3) Shallow stainless steel pans filled 2-3 inches and store in refrigerator 4) Separate into smaller or thinner portions and store in refrigerator 5) Blast chiller 6) Any combination of the above. Use the following approved methods provided on the rapid cooling guideline.
- Obtain a state approved food safety certification course within 60 days of operation or when a Food Safety Manager has left the facility. Maintain copies of food safety certificates (food safety manager and food handler cards) on site.
- Protect the potable water supply with a backflow protection device, as required by applicable plumbing codes. All plumbing, plumbing fixtures, and grease interceptors shall be installed in compliance with local plumbing ordinances, shall be maintained so as to prevent any contamination, and shall be kept clean, fully operative, and in good repair. Any hose used for conveying potable water shall be of approved materials, labeled, properly stored, and used for no other purpose.
- Ensure all equipment is approved, properly installed, clean, and maintained in good repair. Ensure all appliances are NSF-approved, commercial grade, durable, and easily cleanable.
- Keep potentially hazardous foods (PHF) cold at 41°F or below or hot held at 135°F or above. Immediately discontinue storing PHF at room temperature.
- Provide walls / ceilings using materials that are durable, smooth, nonabsorbent, light-colored, and washable surfaces. All floor surfaces, other than the customer service areas, shall be approved, smooth, durable, and made of nonabsorbent material that is easily cleanable. Approved base coving shall be provided in all areas, except customer service areas and where food is stored in original unopened containers. Food facilities shall be fully enclosed. All food facilities shall be kept clean and in good repair.