T&T SUPERMARKET CITY CENTER

June 23, 2025 — Passed

19 red flags recorded · 150 minutes on site.

• The floor finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms. (Code 114268)
• All equipment shall be installed on castors, six (6) inch high round metal legs, or on a minimum four (4) inch high curb or pedestal with a continuously coved base at the juncture. (Code 114130, 114169)
• Hand sinks shall be sufficient in number and conveniently located so as to be accessible at all times. (Code 113953, 113953(b))
• Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius coving and shall extend up the wall at least 4 inches. (Code 114268)
• Provide a designated area for refuse, recyclables, and compost separate from food, equipment, and utensils. (Code 114244, 114245)
• Wall and ceiling finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms. (Code 114271)
• Provide a 3-compartment sink with two integral metal drainboards for manually washing, rinsing, and sanitizing equipment and utensils. (Code 114099)
• The water supply shall be from a water system approved by the local enforcement agency. (Code 114192, 113953)
• Equipment for cooling, e.g. ice machine, walk-in cooler/freezer, shall be sufficient in number and capacity to ensure proper food temperature control. (Code 114153)
• Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens, and single-use articles cannot occur. (Code 114256)
• Toilet rooms shall be separated by well-fitted, self-closing doors that prevent the passage of flies, dust or odors. (Code 114276, 114149, SF Health Code Section 440.5)
• All permanent food facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a food preparation sink with a single integral drainboard. The food preparation sink shall have a minimum dimension of 18"x18"x12" (LxWxD) with an integral drainboard at least 18"x18" (LxW). (Code 114163)
• Equipment that discharges liquid waste, e.g. food preparation sinks, dishwashing machines, steam tables, ice machines and bins, espresso machines, walk-in refrigeration units, shall have approved indirect drainage through an air gap into a floor sink or other approved receiving vessel. (Code 114193, 114193.1, 114269)
• Floor drains shall be installed in floors that are water-flushed for cleaning and in areas where pressure spray methods for cleaning equipment are used. (Code 114193, 114193.1, 114269)
• All new and used equipment and utensils shall be certified or classified for sanitation by an American National Standards Institute (ANSI) accredited certification program, e.g. NSF, ETL Sanitation, UL Sanitation, CSA Sanitation. (Code 114130, 114169)
• A food facility shall at all times be constructed, equipped, and maintained, and operated as to prevent the entrance and harborage of animals, birds, and vermin, including, but not limited to rodents and insects. (Code 114266, 114257, 114257.1, 114259)
• An air gap between the water supply inlet and the flood level rim of the plumbing fixture shall be at least twice the diameter of the water supply inlet and may not be less than 1 inch. (Code 114193, 114193.1, 114269)
• Food on display shall be protected from contamination by approved a sneeze guard (e.g. vertical glass sneezeguard 60" Above Finished Floor). (Code 114060)
• At least one curbed cleaning facility or janitorial sink equipped with hot and cold water and a drain shall be provided and conveniently located. (Code 114279, 114281, 114282)