AIC

June 10, 2025 — Passed

0 red flags recorded · 60 minutes on site.

No violations recorded on this inspection.

March 21, 2025 — Passed

18 red flags recorded · 135 minutes on site.

• Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens, and single-use articles cannot occur. (Code 114256)
• Toilet rooms shall be separated by well-fitted, self-closing doors that prevent the passage of flies, dust or odors. (Code 114276, 114149, SF Health Code Section 440.5)
• Wall and ceiling finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms. (Code 114271)
• A food facility shall at all times be constructed, equipped, and maintained, and operated as to prevent the entrance and harborage of animals, birds, and vermin, including, but not limited to rodents and insects. (Code 114266, 114257, 114257.1, 114259)
• The water supply shall be from a water system approved by the local enforcement agency. (Code 114192, 113953)
• An air gap between the water supply inlet and the flood level rim of the plumbing fixture shall be at least twice the diameter of the water supply inlet and may not be less than 1 inch. (Code 114193, 114193.1, 114269)
• Toilet rooms shall be vented to the outside air by means of an openable, screened window, an air shaft, or a light-switch-activated exhaust fan, consistent with the requirements of local building codes. (Code 114276, 114149, SF Health Code Section 440.5)
• All equipment shall be installed on castors, six (6) inch high round metal legs, or on a minimum four (4) inch high curb or pedestal with a continuously coved base at the juncture. (Code 114130, 114169)
• The floor finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms. (Code 114268)
• Sink compartments shall be large enough to accommodate the immersion of the largest equipment and utensils. (Code 114099)
• At least one curbed cleaning facility or janitorial sink equipped with hot and cold water and a drain shall be provided and conveniently located. (Code 114279, 114281, 114282)
• Provide a designated area for refuse, recyclables, and compost separate from food, equipment, and utensils. (Code 114244, 114245)
• Floor drains shall be installed in floors that are water-flushed for cleaning and in areas where pressure spray methods for cleaning equipment are used. (Code 114193, 114193.1, 114269)
• Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius coving and shall extend up the wall at least 4 inches. (Code 114268)
• Equipment for cooling, e.g. ice machine, walk-in cooler/freezer, shall be sufficient in number and capacity to ensure proper food temperature control. (Code 114153)
• Equipment that discharges liquid waste, e.g. food preparation sinks, dishwashing machines, steam tables, ice machines and bins, espresso machines, walk-in refrigeration units, shall have approved indirect drainage through an air gap into a floor sink or other approved receiving vessel. (Code 114193, 114193.1, 114269)
• Conduits of all types shall be installed within walls as practicable. When otherwise installed, they shall be mounted or enclosed so as to facilitate cleaning. (Code 114271(d))
• Provide minimum 6 inches high side splashguard(s) with rounded corners. (Code 113953, 113953(b))