Embarc Wines

September 11, 2024 — Passed

0 red flags recorded · 30 minutes on site.

No violations recorded on this inspection.

August 7, 2024 — Passed

0 red flags recorded · 25 minutes on site.

No violations recorded on this inspection.

August 7, 2024 — Passed

0 red flags recorded · 20 minutes on site.

No violations recorded on this inspection.

May 29, 2024 — Passed

7 red flags recorded · 60 minutes on site.

• Equipment that discharges liquid waste, e.g. food preparation sinks, dishwashing machines, steam tables, ice machines and bins, espresso machines, walk-in refrigeration units, shall have approved indirect drainage through an air gap into a floor sink or other approved receiving vessel. (Code 114193, 114193.1, 114269)
• Multiuse food -contact surfaces shall be smooth, free of breaks, open seams, cracks, chips, inclusions, pits, and similar imperfections, free of sharp internal angles, corners, and crevices, finished to have smooth welds and joints. (Code 114130.1, 114130.3)
• All new and used equipment and utensils shall be certified or classified for sanitation by an American National Standards Institute (ANSI) accredited certification program, e.g. NSF, ETL Sanitation, UL Sanitation, CSA Sanitation. (Code 114130, 114169)
• Provide a designated area for refuse, recyclables, and compost separate from food, equipment, and utensils. (Code 114244, 114245)
• The water supply shall be from a water system approved by the local enforcement agency. (Code 114192, 113953)
• Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens, and single-use articles cannot occur. (Code 114256)
• Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius coving and shall extend up the wall at least 4 inches. (Code 114268)

April 24, 2024 — Passed

7 red flags recorded · 60 minutes on site.

• Pressurized warm water shall be provided by all handwashing sinks for a minimum of 15 seconds through a mixing valve or combination faucet. At handwashing sinks where the water temperature provided is not readily adjustable at the faucets, warm water between 100°F-108°F shall be provided. (Code 114192, 113953)
• After use, mops shall be placed in a position that allows them to air-day without soiling walls, equipment, or supplies, e.g. wall-mounted mop rack. (Code 114279, 114281, 114282)
• All new and used equipment and utensils shall be certified or classified for sanitation by an American National Standards Institute (ANSI) accredited certification program, e.g. NSF, ETL Sanitation, UL Sanitation, CSA Sanitation. (Code 114130, 114169)
• Wall and ceiling finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms. (Code 114271)
• A food facility shall at all times be constructed, equipped, and maintained, and operated as to prevent the entrance and harborage of animals, birds, and vermin, including, but not limited to rodents and insects. (Code 114266, 114257, 114257.1, 114259)
• Equipment that discharges liquid waste, e.g. food preparation sinks, dishwashing machines, steam tables, ice machines and bins, espresso machines, walk-in refrigeration units, shall have approved indirect drainage through an air gap into a floor sink or other approved receiving vessel. (Code 114193, 114193.1, 114269)
• The water supply shall be from a water system approved by the local enforcement agency. (Code 114192, 113953)