January 11, 2024 — Passed
12 red flags recorded · 60 minutes on site.
- Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius coving and shall extend up the wall at least 4 inches.
- Provide a designated area for refuse, recyclables, and compost separate from food, equipment, and utensils.
- Food on display shall be protected from contamination by approved a sneeze guard (e.g. vertical glass sneezeguard 60" Above Finished Floor).
- The water supply shall be from a water system approved by the local enforcement agency.
- Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens, and single-use articles cannot occur.
- Pressurized warm water shall be provided by all handwashing sinks for a minimum of 15 seconds through a mixing valve or combination faucet. At handwashing sinks where the water temperature provided is not readily adjustable at the faucets, warm water between 100°F-108°F shall be provided.
- A permanent food facility shall provide clean toilet facilities in good repair for use by employees.
- All new and used equipment and utensils shall be certified or classified for sanitation by an American National Standards Institute (ANSI) accredited certification program, e.g. NSF, ETL Sanitation, UL Sanitation, CSA Sanitation.
- Hand sinks shall be sufficient in number and conveniently located so as to be accessible at all times.
- Wall and ceiling finish shall be smooth, durable, easily cleanable, and non-absorbent in all areas where there is food service or preparation, open food storage, warewashing, janitorial service, trash storage, and employee restrooms.
- Equipment for cooling, e.g. ice machine, walk-in cooler/freezer, shall be sufficient in number and capacity to ensure proper food temperature control.
- Provide a floor plan showing the path-of-travel to the refuse storage area.